QBZ-191 service rifle family

yikustudi

Just Hatched
Registered Member
What makes you think that?

The configuration of the upper and lower and the pins isn't identical to the AR, but it should open up similarly, given the positioning of the forward pin on the 191.
The positioning of the pins on 191 and receiver configuration is probably closest to QBZ03, with the AR15 style buffer tube and stock.

I.e.: the upper receiver (light blue) and lower receiver (green) have two push pins with their holes visible, one immediately in front of the magazine well and one immediately above where the buffer tube/stock joins the receiver.

I'm not sure what part of this resembles the G3 over the AR15.

View attachment 70709
Oh yeah nevermind, you're right and i was wrong. I was looking at the picture in my phone and the low res images didn't help either. lol.

now that i see it more clearly, you're definitely correct. i thought at first that the takedown pin hole was directly connected to the yellowed parts which is the buffer assembly so when you took the pin out the buffer and stock assembly can be taken off.

From the looks of it, The upper does seems like it can be hinged open from the front pivot pin and then you can take the bolt carrier group out, similar to an AR15.

Is there any images of it being field stripped?

The lowers receiver seems to be made from polymer, because the firing control group has a housing. that or the reason was so it could be easily disassembled for cleaning.
 

Aniah

Senior Member
Registered Member
Oh yeah nevermind, you're right and i was wrong. I was looking at the picture in my phone and the low res images didn't help either. lol.

now that i see it more clearly, you're definitely correct. i thought at first that the takedown pin hole was directly connected to the yellowed parts which is the buffer assembly so when you took the pin out the buffer and stock assembly can be taken off.

From the looks of it, The upper does seems like it can be hinged open from the front pivot pin and then you can take the bolt carrier group out, similar to an AR15.

Is there any images of it being field stripped?

The lowers receiver seems to be made from polymer, because the firing control group has a housing. that or the reason was so it could be easily disassembled for cleaning.
No images of field stripping. What you see here is what you get so far.
 

by78

General
Some nice screen grabs from a PLAN promo video. Note the IR lasers.


51130510057_02b98d8b41_o_d.jpg

51132296095_e139b34a57_o.png

51131185941_3e53747efa_o.jpg

51131186006_240638f865_o.jpg
 
Last edited:
Top